Euclidean Clustering Segmentation With Normals
Description
This operator performs clustering segmentation on the input point cloud based on the Euclidean distance between points. It aggregates spatially close points into independent clusters. If the distance between a point and any point in an existing cluster is less than the set "Search Radius", or if it can connect to a point within the radius, the point is assigned to that cluster. The operator finally outputs a list of point clouds, where each point cloud represents a segmented cluster.
Overview
Uses a connected component algorithm based on Euclidean distance to group points with spatial distance below a threshold into the same cluster, suitable for scenes where objects have obvious spatial separation.
Scenarios
-
Instance Segmentation: Segmenting physically separated objects in the scene into independent point cloud clusters. For example, segmenting multiple parts on a conveyor belt or multiple cups on a table.
-
Noise Removal: By setting "Minimum Cluster Points", point cloud clusters with too few points, which may be background noise or sensor errors, can be effectively filtered out.
-
Point Cloud Preprocessing: Segmenting the raw point cloud or point cloud within an ROI into units representing different objects before performing tasks like object recognition or pose estimation.
-
Functionally very similar to the "Connected Component Segmentation" operator, as both usually utilize spatial proximity for clustering.
Inputs and Outputs
Inputs |
Point Cloud: The input point cloud or list of point clouds to be segmented. |
Outputs |
Segmented point cloud: The list of point cloud clusters obtained after segmentation. |
Parameters
Search Radius
Description |
|
Parameter Range |
[0, 200], Default value: 5, Unit: mm |
Parameter Range |
Values/Range: [0, 200] Default: 5 |
Minimum Cluster Points
Description |
Used to filter out point cloud clusters that are too small. Increasing this value can remove more small clusters (usually considered noise), but if set too high, it may filter out valid objects with smaller sizes. |
Parameter Range |
[1, 10000000], Default value: 100 |
Parameter Range |
Values/Range: [1, 10000000] Default: 1000 |
Maximum Cluster Points
Description |
Used to filter out point cloud clusters that are too large. Suitable for scenarios where extra-large clustering results such as background or ground need to be excluded. Usually, keep the default value (a very large number) unless there is a special requirement. |
Parameter Range |
[1, 10000000], Default value: 4000000 |
Parameter Range |
Values/Range: [1, 10000000] Default: 4000000 |
Keep All Results
Description |
Determines whether to output all clustering results that meet the size conditions. |
Tuning Instructions |
|
Parameter Range |
Values/Range:
Default: True |
Number of Results to Keep
Description |
The operator sorts all segmentation results by point cloud quantity from large to small. If this parameter is set to N, only the top N sorted point cloud clusters are output. For example, setting it to 1 means only outputting the cluster with the most points. |
Parameter Range |
[1, 1000], Default value: 1 |
Parameter Range |
Values/Range: [1, 1000] Default: 1 |
Enable Sorting
Description |
Determines whether to sort the final output list of point cloud clusters by point count from large to small. |
Tuning Instructions |
If subsequent processing depends on the size order of point cloud clusters, this item should be kept enabled. |
Parameter Range |
Default: True |